0:00
I want to show you a trick that has usefulness in a lot of different situations
0:04
The thing I want to show you is the way there's a gap here, an uneven gap
0:08
It's tight at the bottom between these two boards and there's a gap at the top
0:12
The solution is quite simple and involves a process called kerfing. I'm going to use this multi-tool
0:18
I am going to plunge this in all along the length of this joint
0:25
The kerf of the blade will cut more down here where it's currently touching
0:30
than it will cut up here. It probably won't cut anything up here. I'm going to move the board over a little bit, hold it in place, and then do it again
0:37
And after three or four of these attempts, that gap will disappear
0:41
There we go. Now, that's as tight as it needs to be
