I hope you found this content useful!
Your generous support helps me produce more practical, hands-on content that I hope you’ll find useful.
Steve Maxwell
Similar Posts
WOODWORKING: Assess The Ends of Boards, Not Just the Face
I’ve noticed that most woodworkers start assessing a board by looking at its face, but if this is where your investigations end, you’re missing out on insights that can lead to a lot of creative control and better woodworking. That’s…
“How Can I Stop Sap From Bleeding Out Of My Tongue And Groove Siding?”
Sap oozing from softwood lumber beams is a perennial problem, especially with thick wood in sunny locations. Stain blocking primer is worth a try, but periodic scraping and rubbing with turpentine is the best option for removal. Sap from softwoods…
Q&A OF THE WEEK: “How Do I Finish a Wooden Countertop”
Q: How should I finish a 3 foot wide x 10 foot long lodgepole pine countertop I’m making for a kitchen and bar? I want the wood to be protected from spills. A: The challenge with every wooden countertop is…
What should I use for dust control in a basement woodworking shop I’m creating?
What should I use for dust control in a basement woodworking shop I’m creating? I’ll be using a tablesaw, router table, bandsaw and sanding equipment. That’s a great question because dust control is often overlooked when setting up a shop….
WOODWORKING: Ripping Versus Crosscutting Lumber
Wood is very different when cutting parallel to the grain (ripping), compared with cutting across the grain (crosscutting). The video below explains.
